Por favor, use este identificador para citar o enlazar este ítem: http://bibdigital.epn.edu.ec/handle/15000/16838
Título: Diseño e implementación de un sistema para vigilancia y bloqueo remoto de vehículos mediante un smartphone y tablet con acceso a Internet
Autor: Morales Aguirre, Henry Sebastián
Palabras clave: INDUSTRIA DE INSTRUMENTACION
MICROPROCESADORES
REDES DE INFORMACION
PROGRAMACION
Fecha de publicación: 11-nov-2016
Editorial: Quito, 2016.
Citación: Morales Aguirre, H. S. (2016). Diseño e implementación de un sistema para vigilancia y bloqueo remoto de vehículos mediante un smartphone y tablet con acceso a Internet. 168 hojas. Quito : EPN.
Resumen: The aim of this project was to implement a security system for vehicles using current technologies and take advantage of the growing use of both Internet and smart devices. As a solution it was designed and implemented a system for monitoring and remote lock for vehicles, which allows the user, by using an app one designed for Android-based smartphones and tablets to receive information about the status of the vehicle from an arduino-based control board installed inside the vehicle. Additionally, the application can also lock the vehicle if required. Communication between the control board and the application is done through a WIFI network or Internet. After conducting performance tests, the following results were obtained: the application obtains without error the state of the vehicle (doors, sensors and motor), with a response time ranging from 1.03 to 1.98 seconds while the image reception have a delay of 1 to 5 seconds, depending on the Internet speed. On the other hand, reliability percentage of 91.57% was achieved in the connectivity.
Descripción: El objetivo de este proyecto fue implementar un sistema de seguridad para vehículos que utilice las tecnologías actuales y aproveche el creciente uso tanto de de Internet como de los dispositivos inteligentes. Como solución se diseño e implementó un sistema de vigilancia y bloqueo remoto para vehículos, el cual permite al usuario, mediante el uso de una aplicación diseñada para smartphones y tablets con sistema Android, recibir información sobre el estado del vehículo desde una placa de control diseñada en base a arduino instalada dentro del vehículo. Adicionalmente, la aplicación también puede bloquear el vehículo de ser necesario. La comunicación entre la placa de control y la aplicación se realiza mediante una red WIFI o Internet. Después de realizar las pruebas de funcionamiento, se obtuvieron los siguientes resultados: la aplicación obtiene sin errores los datos del estado del vehículo (puertas, sensores y motor), con un tiempo de respuesta de 1.03 a 1.98 segundos mientras que para la recepción de las imágenes se tiene un retardo de 1 a 5 segundos, estos tiempos dependen de la velocidad del Internet. Por otro lado, se obtuvo un porcentaje de confiabilidad de la comunicación de 91.57 %.
URI: http://bibdigital.epn.edu.ec/handle/15000/16838
Tipo: bachelorThesis
Aparece en las colecciones:Tesis Electrónica y Control (IEC)

Ficheros en este ítem:
Fichero Descripción TamañoFormato 
CD-7417.pdf20,55 MBAdobe PDFVisualizar/Abrir


Los ítems de DSpace están protegidos por copyright, con todos los derechos reservados, a menos que se indique lo contrario.