Bitte benutzen Sie diese Kennung, um auf die Ressource zu verweisen: http://bibdigital.epn.edu.ec/handle/15000/21727
Titel: Determinación del cambio de rugosidad superficial en función de la velocidad de avance en el corte por chorro de agua abrasivo aplicado a una lámina de aluminio de 1 mm de espesor.
Autor(en): Vaca Pardo, Victor Hernán
Stichwörter: AGUA A BAJA PRESIÓN
MANUFACTURA
Erscheinungsdatum: 5-Jul-2021
Herausgeber: Quito, 2021
Zitierform: Vaca Pardo, V.H. (2021). Determinación del cambio de rugosidad superficial en función de la velocidad de avance en el corte por chorro de agua abrasivo aplicado a una lámina de aluminio de 1 mm de espesor. 119 hojas. Quito : EPN.
Zusammenfassung: Abrasive waterjet cutting technology at relatively low pressure was studied in this document. This study will contribute to the strengthening of the Ecuadorian industry by presenting an alternative for cutting thin aluminum sheets. Firstly, a study of the state of the art of this technology was carried out which allowed the assembly of an abrasive water jet cutting system. Then, cutting samples were obtained by varying the abrasive flow rate and the transverse cutting speed using said system. These samples were then tested with a microscope and a roughness meter and the resulting cut characteristics such as surface characteristics: roughness and drag, as well as geometric characteristics: taper angle, were determined. Subsequently, these results were associated with their total cost to propose an optimal cutting point or to give the reader the option to define the cutting parameters according to their application. A nomogram was made to study the characteristics of the cut in which it was found that as the transverse cutting speed is increased, surface roughness decreases and with an increase in the abrasive flow rate surface roughness increases.
Beschreibung: En el presente documento se estudió la tecnología de corte por chorro de agua abrasivo a relativamente baja presión. Esto permitirá aportar al fortalecimiento de la industria ecuatoriana al presentar una alternativa de corte de láminas de aluminio de espesores delgados. Para esto se realizó un estudio del estado del arte de la tecnología que permitió el ensamblaje de un sistema de corte por chorro de agua abrasivo. Con la ayuda de este sistema se obtuvieron muestras variando la dosificación de abrasivo y la velocidad transversal de corte. Estas muestras fueron analizadas con la ayuda del microscopio y rugosímetro y así se determinaron las características resultantes del corte relacionadas con la superficie: rugosidad y arrastre, así como geométricas: conicidad. Posteriormente estos resultados también fueron asociados a su costo total para proponer un punto óptimo de corte o que el lector pueda definir los parámetros seleccionados según su aplicación. Se realizó un nomograma para estudiar las características del corte en el cual se encontró que conforme se aumenta la velocidad transversal de corte se reduce rugosidad superficial y con el aumento del flujo de abrasivo aumenta la rugosidad.
URI: http://bibdigital.epn.edu.ec/handle/15000/21727
Art: bachelorThesis
Enthalten in den Sammlungen:Tesis Mecánica (IM)

Dateien zu dieser Ressource:
Datei Beschreibung GrößeFormat 
CD 11212.pdf3,69 MBAdobe PDFÖffnen/Anzeigen


Alle Ressourcen in diesem Repository sind urheberrechtlich geschützt.