Implementación de un sistema de extracción de aire y cableado de las mesas de trabajo del laboratorio de instalaciones eléctricas del aula 33.

Abstract

The purpose of the project was to improve the work environment, trying to reduce and eliminate gases produced by the effect of welding carried out within the electrical installation’s laboratory; the cabling of the worktables was assembled with the aim that these conductors do not affect the free movement of students and teachers who use the facilities; as well as that this wiring is adequate to avoid and reduce possible voltage drops in the laboratory. Section one presents the introduction of the project, the context of the problem, the location of the project, operating time, some of the fundamentals used and the objectives that were established for the realization and assembly of the system. Section two describes the methodology used to execute the project. Next, in section three the results and the discussion are shown, the study of the initial conditions is presented, as well as the conditions in which the new laboratory remains, the parameters that were established for the project design are attached, in addition, the maintenance manual is developed specifying the actions that must be considered to extend the useful life of the facilities. Section four describes the conclusions and recommendations based on the results obtained, problems encountered, and new knowledge acquired during the execution of the project.