Implementación de un sistema de iluminación automático para el laboratorio de tecnología industrial.

Abstract

This project is based on implementing an appropriate lighting system for the industrial technology laboratory according to the NEC standard, through a LED-type lighting system. The laboratory will be divided into two areas for a better design and implementation of the project, one for control and one for instrumentation. Where each of them will have two circuits, a standby circuit that will have a lighting level greater than or equal to 150 [lx] and a second working circuit that together with the first will have a lighting level greater than or equal to 500 [lx]. Chapter one details a brief introduction about the integration work, specifying its extent as well as the objectives of this project and a brief explanation of the fundamental theory for its development. Chapter two refers to the methodology used to meet the objectives of the project, this chapter details: the technical requirements of the laboratory, the design of the lighting system and the dimensioning of cables and protections. Chapter three describes the results obtained at the end of the project, where the selected luminaires, cables and selected protections are shown and finally a comparative table of before and after with the respective lighting level measurements. Chapter four details the conclusions and chapter five describes the recommendations established at the end of the installation of the lighting system. This project is directly linked to the "AUTOMATIC LIGHTING CONTROL" developed by Chilig Paneluisa Cristian David component for the activation and deactivation of each lighting mode in the 2 areas of the laboratory.