Diseño de un molino de pines: sistema de potencia, Estructura.

Abstract

The development corresponds to the design together with the selection of the power component and structure. For the development of the components, primary information and manufacturers were collected from sources, then it was passed to the development of the house of quality in order to obtain the basic specifications, and then to carry out an analysis of the different functions that will allow defining the main modules and the functions that each one of these fulfills, then a matrix of weighted criteria is established for each solution, all with the aim of defining the best possible solution according to the requirements given by the user's voice. Once the best solution is established, the necessary power for grinding is determined, which for the present case is 1.09 HP, then the selection for the transmission system is made, obtaining a 135mm drive pulley which will work with a pulley 67 mm lead, which will be connected by a 3V band. This mill will also have a security guard system which will be based on the B11.19 standard. On the other hand, for the mill table, it has been decided to use 40x40x3mm angular profiles, in addition to the structure of this table, miter-type joints will be used and a 1/8 6011 electrode will also be used. On the other hand, for the electrical system, the number of conducting wire has been determined, together with the type of contactor suitable for this table, thus determining the power and control circuit.